Product Construction
- Fully Hardened Special tool Steel/li>
Product Features
- Toolmaker’s Vee block used for mounting circular items when machining or marking out. The clamp is slightly narrower than the block, allowing the block to be laid on its side for machining features at right angles to each other. There is an adjustable stop fitted to the clamp screw which can be positioned so that it rests on the machine table to give additional support when machining with the block on its side. There are holes tapped in the base and the sides of the block for securing to angle plates, face plates or other fixtures.
- Constructed from Fully Hardened Special tool Steel.
- Groove at the stepped end, right angled to the base, providers a handy means for holding shouldered studs, round pins etc
- Four 3/8″ – 16 tapped holes, two in the base and one on each side allow attachment to an angle iron which can then be attached to a lathe face plate or held by a magnetic chuck.
Ordering Details
Article No. |
Order No. |
Block Length |
Block Width |
Block Height |
Clamping Capacity |
||||
Inch |
mm |
Inch |
mm |
Inch |
mm |
Inch |
mm |
||
SA/TM-UVB/90 |
140045 |
3-35/64 |
90 |
1-57/64 |
48 |
1-57/64 |
48 |
1-19/64 |
33 |
Applications
