sendenquiry

Product Construction

  • Hardened Steel Body
  • Ground Finish

Product Features

Taps are used for cutting internal threads in predetermined holes. These perform best in materials where the cutting action results in chips which break up readily and do not present problems of chip disposal. Taps are usually used in sets of 3 (Taper, Plug and bottoming)

The taper tap is used to begin the tapping process, but this will not cut the thread down to the bottom of the hole
because it is tapered back for 6 to 7 threads. This tap cuts a complete thread when it is cutting above the taper. It is the only tap needed when tapping holes that extend through thin sections.

The plug tap supplements the taper tap for tapping holes in thick stock.

The bottoming tap is not tapered. It is used to cut full threads to the bottom of a blind hole.

Ordering Details

Article No.

Order No.

Nominal Size

mm

Pitch (mm)

SA/TAP-M2

280044

2

0.4

SA/TAP-M3

280045

3

0.5

SA/TAP-M4

280046

4

0.7

SA/TAP-M5

280047

5

0.8

SA/TAP-M6

280048

6

1

SA/TAP-M7

280049

7

1

SA/TAP-M8

280050

8

1

SA/TAP-M8/125

280051

8

1.25

SA/TAP-M9

280052

9

1

SA/TAP-M9/125

280053

9

1.25

SA/TAP-M10

280054

10

1

SA/TAP-M10/125

280055

10

1.25

SA/TAP-M10/150

280056

10

1.5

SA/TAP-M11

280057

11

1.5

SA/TAP-M12

280058

12

1

SA/TAP-M12/125

280059

12

1.25

SA/TAP-M12/150

280060

12

1.5

SA/TAP-M12/175

280061

12

1.75

SA/TAP-M14

280062

14

1

SA/TAP-M14/125

280063

14

1.25

SA/TAP-M14/150

280064

14

1.5

SA/TAP-M14/2

280065

14

2

SA/TAP-M16/150

280066

16

1.5

SA/TAP-M16/2

280067

16

2

SA/TAP-M18/150

280068

18

1.5

SA/TAP-M18/2

280069

18

2

SA/TAP-M18/250

280070

18

2.5

SA/TAP-M20/150

280071

20

1.5

SA/TAP-M20/2

280072

20

2

SA/TAP-M20/250

280073

20

2.5

SA/TAP-M22/150

280074

22

1.5

SA/TAP-M22/250

280075

22

2.5

SA/TAP-M24/3

280076

24

3

Applications

application

Downloads


error: Content is protected !!